Parramatta homes come in two flavours, and both of them waste storage. The older brick and fibro places around Harris Park and North Parramatta have those awkward dead corners, narrow hallways and the gap under the stairs that nobody knows what to do with. The newer apartments going up around the CBD and Westmead give you a big blank living wall and a study nook the builder left bare. We build joinery into both. A TV and media unit that runs the full wall and hides every cable. A study nook with a proper desk top, drawers and shelving above so it stops being a dumping ground. Under-stair storage with pull-out drawers instead of a cupboard you have to crawl into. We are a family-run joinery based just down the M7 in Liverpool, so Parramatta is a short run for us, and we have been building this gear for 12 years. Everything is made to the actual room, not bought off a shelf and shimmed to fit. We measure on site, give you a fixed-price quote with no provisional sums, and because one team handles the cabinetry, the painting and any electrical for downlights or power points, you are not chasing separate trades. As a licensed NSW contractor, contractor number 383725C, we stand behind the work. Most custom joinery jobs are on site for around three weeks, often less for a single unit, and we hand it back clean and ready to load.
We come to your Parramatta home, measure the wall, the nook or the under-stair void, and check for any power or data you want built in. You get one fixed-price quote covering the cabinetry, finishes and any electrical. No provisional sums and no surprise extras turning up partway through the job.
We settle the layout, shelf spacing, door and drawer finishes, handles and how it meets the floor and ceiling. We work to the real measurements of your room so it sits flush and looks built-in, not bolted on. Once you sign off, the design is locked and the team builds to that exact spec.
Your unit is built in our workshop while we book in any painting or electrical in the right order. Because it is one team, nothing falls between trades. You get a clear start date and a realistic finish, usually around three weeks for a full storage wall and quicker for a single TV unit or nook.
We fit the joinery, scribe it to the walls, hang doors, fit drawers and adjust the soft-close, then paint and connect any power. Before we leave we clean up and walk you through it. You get your warranty paperwork and storage you can start using straight away.
Most custom joinery in Parramatta lands between $2,000 and $8,000 for a TV unit, shelving run or media wall. A simple set of floating shelves or a single cabinet sits at the lower end, while a full-height storage wall with doors, drawers and integrated lighting sits up near the top. Study nooks and under-stair fit-outs vary a fair bit with the size of the space and how many drawers and pull-outs you want. We give you one fixed-price quote up front with no provisional sums, so the figure you sign is the figure you pay. Two-pac paint finishes cost more than laminate, and we will lay out both options so you can decide where the budget goes.
Once we have measured and locked in the design, a typical Parramatta job is on site for around three weeks, though a single TV unit or a study nook often goes in much quicker than that. Most of the time is workshop manufacture, where your unit is built to the exact measurements of your room. The on-site install itself is usually only a day or two for a single piece, longer for a full storage wall that needs painting and electrical. Because we run one team across cabinetry, painting and electrical, we are not waiting on outside subbies, so the timeline stays tight and we can give you a finish date you can plan around.
Yes, under-stair storage is one of the most common jobs we do in the older brick and fibro homes around Harris Park and North Parramatta. That space is almost always wasted as a single deep cupboard you have to crawl into. We replace it with pull-out drawers, shoe racks or a combination of cupboards and open shelving so every bit of the void earns its keep. We measure the angle of the stair stringer and build to it, so the unit follows the slope cleanly rather than leaving gaps. As a licensed NSW contractor we handle it properly, and because it is built to your stairs it sits flush like it was always there.
We are a family-run business, not a franchise, so you deal with the same people from the first measure to the day we hand it over. We are based in Liverpool, so Parramatta is a quick run for us and we are never far away if you need us after the job. Twelve years in, we have built everything from tight under-stair fit-outs in older homes to full media walls in newer CBD apartments. One team covers cabinetry, painting and electrical, so there is no chasing separate contractors and no finger-pointing. You get a fixed-price quote, a roughly three-week turnaround, and a licensed NSW contractor, number 383725C, standing behind the work.
InsideOut Joinery & Renos is a family-run custom joinery and renovation business based in Liverpool, Sydney NSW 2170, serving homeowners Sydney-wide. Call 02 5000 0402 or email info@insideoutjoinery.au. One team covers every trade, with a typical 3-week turnaround, trade-cost appliances and 12 years of experience. Licensed contractor — licence 383725C, ABN 62 912 909 739.